Where are the serial port settings for a fiber optic switch located

There are two ports on the left side of the switches reserved for functions outside of communicating with the node and storage array. The ports are labeled: the serial port used to configure the switch. The Cisco MDS 9148S switch provides the following types of ports: Console port (Interface Module)—An RS-232 port that you can use to create a local management connection. MGMT 10/100 Ethernet port (Interface Module)—An Ethernet port that you can use to access and manage the switch by IP address. A vertical line, called a pipe, indicates a choice within a set of keywords or arguments. [x | y] Optional alternative keywords are grouped in brackets and separated by vertical bars. Cisco Catalyst 9500. These are located on U28 and U27 respectively. This fiber switch utilizes OEO Technology. The Primary Remote Control is an RJ45 port that is 10/100 Base-T Ethernet and is IP addressable. Access either of two LC Duplex Fiber Optic Networks from one computer connected. The switch is typically grounded during installation and provides an ESD port to which you can connect your wrist strap. Do not remove and insert a transceiver more often than is necessary. One of the Ethernet ports can also be used to export analytic. [PDF]